ASSEMBLY / OPERATING INSTRUCTIONS
Leg and footrest assembly
1.
Locate the two front upper legs. Check that the pre-drilled holes are at the front.
Insert the screw into the threaded hole in the highchair frame and rotate the leg clockwise until
it is firmly tightened. Check that the holes are facing forwards.
2.
Locate the pre-drilled holes in the upper front legs, place the
footrest on the holes
3.
Insert the supplied screws
and tighten with a cross-head screwdriver
(not included). Do not tighten the screws
with excessive force. Repeat on the
opposite side.
„Screwholes"
21