Avery Dennison Monarch 9906 Kurzanleitung Seite 5

A d j u s t i n g t h e P r i n t h e a d P r e s s u r e D i a l s
The default setting is least pressure, which provides optimal
printing in most cases. If you see smudging, ribbon wrinkling, or
poor print quality, you may need to adjust the printhead pressure
dials.
The two dials are located on either edge of the printhead
assembly (inside and outside). The dials may be set to different
positions; however, the inside dial should be equal to or more
pressure than the outside dial. When using 4" wide supply both
knobs should be set at equal pressure. Use a coin or flathead
screwdriver to adjust the dials.
Printhead
Pressure Dials
Each dial has four settings:

Least pressure

Light pressure

Medium pressure

Most pressure
Print a test label to check the printhead pressure; make
adjustments as necessary. Refer to the Operator's Handbook for
additional information.
L o a d i n g R i b b o n
Open the cover.
1.
Unlock the printhead by turning the printhead retaining latch.
2.
Lift the printhead assembly using the printhead tab until the
3.
assembly locks into place.
Least
Pressure
Most Pressure
EN-5