Avery Dennison Monarch 9906 Kurzanleitung Seite 10

T r o u b l e s h o o t i n g
This section lists common problems and their solutions.
Problem
Error message
appears during
startup
Does not print.
Does not feed.
Partially printed data.
Light/Heavy printing,
printing shadows or
voids.
Serial bar codes do
not scan.
Liner is wrapped
around platen or peel
roller.
Printer does not read
or program the RFID
tag.
10-EN
Action
Turn off the printer, wait fifteen seconds
and then turn on the printer. Call
Customer Service if the error message
reappears.
Check supply and ribbon, send a
corrected format and batch packet.
Adjust the printhead pressure dials.
Clean the printhead, send a corrected
format packet.
Clean the printhead, change supply,
adjust the print contrast, check the
printhead pressure dials, check the
ribbon.
Leave printhead unlatched when not in
use, use a print speed of 2.5 ips, adjust
the print contrast.
Carefully remove the liner. Make sure
the liner tears at the saw-toothed tear
edge when using backfeed and peel
mode.
See your System Administrator