oneConcept Streamo Cube Bedienungsanleitung Seite 60

EN
BT
Selecting an audio source: Press [ENTER] (4) repeatedly until "BT" appears
on the display.
Make sure that no other BT device is connected to the radio. "No
Connection "will appear on the display.
Activate BT mode on the device that you want to connect. Look for
The radio on the list of detected devices on the BT device (refer to the
instruction manual of the device). Once the devices have found each other,
the radio will appear as 'Streamo' on the BT device.
Select 'Streamo' from the list. If you are required to enter a PIN code, enter
0000 (four zeros). Certain devices may also require you to approve the
connection.
Once the connection has been successful, "Connected" will appear on the
display of the radio.
Start playback on your BT device.
Control the playback from the BT device or from the radio using the Vol+/
Vol- on the device and remote control, Adjust the volume both on the BT
device and the radio.
To disconnect a connected BT device: Press and hold down the Enter button
for 3 seconds. The message "No Connection" will appear on the display.
60