Using The Control Panel - Dantherm HCP 10 Installations- Und Benutzerhandbuch

Using the control panel

Introduction
This part describes how to use the remote control (HCP 10/11). The functionality varies
depending on if any accessory is mounted.
Manual fan speed When pressing this button once, the fan speed will increase one step. When reaching
step 4 it will switch to speed 0 and then again upwards
Week program Press once to select week program operation. The unit will operate in latest used
program. Only remote control (HRC 3) or PC Tool enables you to select
appropriate week program according your local needs.
Week program 11 can be tailor-made also with a mix of fixed fan speeds, as
well as demand mode time periods.
Week program 11 can be programmed with the PC tool.
5 seconds long press will activate demand controlled operation, VOC/RH% sensor kit if
installed.
Demand mode In this mode (Controlled by VOC and RH% sensor (accessory)) the unit will automatically
adjust the ventilation level, to comply with the ventilation needs, measured in the
extract air by the VOC and RH% sensors. This operation mode is only possible if the unit
is fitted with VOC or RH% sensor kit
Summer cooling Summer cooling mode will stop the supply fan, and new colder outside fresh
mode air will be suck in through and open window.
When summer cooling mode is active the LED flashes 5 seconds and goes off I second
LED light permanently to indicate week program
•
LED flashes to indicated auto mode (demand) controlled by the
•
VOC/CO sensors.
2
Press and hold for 5 seconds for enabling or disabling summer
•
cooling mode
Supply fan operation will stop in summer cooling mode.
•
Cold outside air will be supplied into the house directly if opening some
•
windows - exhaust fan will keep extracting air from the house creating an air
flow.
Summer cooling mode can only be activated if outside temp. is above 14°C. If
•
the outside temp. is under 14°C. it will be automatically disable and must be
manually enabled again
Continued overleaf
4