Dantherm HCP 10 Installations- Und Benutzerhandbuch Seite 3

Remote Control HCP 10/11 – Installation and User Manual
Introduction This instruction provides the procedures for installing and using the wired Remote
Control:
Caution Before you start installing, make sure that the power to the unit is switched off.
Before you start Make sure that you have the HCP10/11 and a small screwdriver available before you
start.
Connect the RJ11 cable to the Domestic Ventilation unit using the MODBUS connection
(2).
Connection
1: ETHERNET
2: MODBUS
3: ANTENNA
4: DIGI IN
HCP 10 (with visual alarm only) and
•
HCP 11 (with both visual and acoustic alarm)
•
Description
LAN connecting for wireless router, BMS
Modbus connection for hardware accessory modul (HAC) and
wired control HCP 10/11,
Wireless connection point for proprietary remote control
External digital input, to select specific operations. Parameters
car the PC-tool.
Continued overleaf
1