Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7.
Disconnect the network cable from the camera to switch it to WiFi mode. Press the
"Refresh List" (Aggiorna) button of "EasyTool" to check that the camera appears again
when it is connected to the WiFi network.
8.
If you want the camera to record and store video files on a micro SD card (not included),
plug the micro SD card into the slot when the camera is powered off. Power on the
camera and use the camera's wepgabe or the app to format the card before starting the
recording function.
If you are using a NVR/HVR device it is advisable to assign a static IP address to the
camera: see section 4.5 of this guide to perform this operation.
4.4
HOW TO ADD THE CAMERA TO A WIFI NETWORK USING AP MODE AND
PC
This mode is used to configure the wireless network interface of the camera without wiring it to
the network. It is an alternative to section 4.3.
The camera is automatically set to Access Point mode if it was never configured in a WiFi
network.
A
PC
In this case, network configuration may be performed after having fitted and powered the camera
in its final position.
The following steps must be performed for configuration:
Search from the available WiFi networks on the PC. The camera has a "URM_..."
1.
SSID. Select this SSID to connect the PC to the camera.
2.
Run steps from 1 to 6 described above in section 4.3.
3.
When the camera connects to the configured WiFi, it stops working in Access Point
mode and disconnects from the PC. For this reason, the PC must be connected to
the LAN before pressing the "Refresh List" button of the "EasyTool" program and
detect the camera again in the network.
Run step 8 described above in section 4.3.
4.
4.5
STATIC IP ADDRESS ALLOCATION
This is an optional operation: if the camera has to be recorded by a HVR/NVR device it is
advisable to set a static IP address after having appropriately connected and configured the
camera in the network (see previous sections).
The network parameters of the camera, such as IP address, subnet mask and gateway may be
set and modified using "EasyTool" provided or on the camera web page.
Refer to the complete user manual for details.
with
wireless
network
board
is
needed
to
configure
it.
13
Werbung
