Macnaught POWERLUBE Bedienungsanleitung

Includes m odels
P3-01, P3-01C, P3-02
P3-03, P3-03-TR, P3-20
P3-21, P3-21-01, P3-23
P3-29, P3001, P3002
P3003, P3004,
P6-01, P6-01-01, P6-02
P6-02-02, P6-03, P6-03-02
P6-03-03, P6-03-TR, P6-13
P6-22, P6001, P6002
P6003, P6008
P8001, P8-11, P8-12
P8LF-01, P8-01
Introduction
Thank you for purchasing a Macnaught Powerlube or
Maxilube air operated grease pump.
The POWERLUBE and MAXILUBE high pressure
grease pumps feature a non-corroding 50:1 ratio air
motor.
Important Information
PLEASE READ THIS SAFETY INFORMATION
CAREFULLY BEFORE USE.
Read and retain this instruction manual to assist you
in the operation and maintenance of this product.
'CAUTIONS' are listed throughout this manual to
advise of actions that may cause damage to your
equipment.
This is a 50:1 ratio high pressure grease pump. Be-
cause of the high pressures developed by this pump,
the possibility of fluid injection into the flesh, or eyes,
is a potential hazard.
WARNING
Never allow any part of the human body to come
in front of, or in direct contact with a material
outlet. Never point the nozzle of the gun at your-
self or anyone else.
Never exceed the pressure rating of any component
in the system. Remember, fluid pressure generated
is fifty times the air inlet pressure.
Before operation check hoses for signs of wear,
leaks or loose fittings. Tighten all fluid connections
regularly and replace weak or damaged hose.
If accidental injection should occur, seek imme-
diate emergency medical attention.
PA62 Issue 19 © 2013
上海盈众工贸有限公司代理热线：4007032818
POWERLUBE & MAXILUBE
AIR OPERATED GREASE PUMP
INSTRUCTION MANUAL
Assembly Procedure (P3 and P6)
Figure 1
Assembly Procedure (P3 and P6)
Figure 3
Apply thread tape or other thread sealant to both
ends of the high pressure grease hose. Pass the
hose through the lid assembly and screw the hose
into the pump outlet tightly. Screw the other end of
the hose into the ZSB swivel on the inlet of the B2
booster gun.
Figure 2
Figure 4
Page 1 of 24