Changing The Shears; Lubrication; Storage; Controlling The Oil Level - Zipper Mowers ZI-GPS70G Betriebsanleitung

14.1.5 Changing the shears

At first you have to loosen the nuts 35 and 36 (Fig. a).
Now remove the nuts 37 (Fig. b).
Then dismantle the guiding bar 38 (Fig. c).
Now loosen and remove the screws 39 (Fig. d).
Loosen the socket screws 40 and remove the cap 41 (Fig. e).
Then you have to disassemble the gasket 42 and the safety cover 43 (Fig. f).
Now lift the connecting rod 44 out of the cam gear.
Take care that you do not lose the spacer 45 (Fig. g).
Now you can change the shears (Fig. h).
For fitting the new shears you have to do these steps backwards.

14.1.6 Lubrication

After cleaning you have to lubricate all the moving parts. Spray the chain with a chain spray.
Every 15 working hours you must squeeze some grease into the grease nipples of the twig saw
31 (Fig. E) and of the hedge trimmer 32 (Fig. G).

14.1.7 Storage

When the machine is stored longer than 30 days:
Drain the fuel out of the fuel tank.
Take off the spark plug and pour some drops of oil into the cylinder. Turn the engine
some times using the cable control so the oil in the cylinder gets evenly distributed.
Clean the spark plug and fit it again.
Cover the machine and store it at a dry and clean place.

14.1.8 Controlling the oil level

Before using the twig saw you have to control the oil level of the oil tank 30 for the twig saw (Fig.
E). Refill it when there's too less oil in it.
Z.I.P.P.E.R MASCHINEN GmbH
Gartenpflegeset / Garden maintenance set ZI-GPS70G / ZI-GPS182G
www.Zipper-maschinen.at
MAINTENANCE
Seite 49