Operation Instructions; Cold Starting; Warm Starting; Stopping - Zipper Mowers ZI-GPS70G Betriebsanleitung

13.2

Operation Instructions

Do not operate the engine at maximum speed right from the start. The engine
itself reaches its maximum capacity after the first 10 hours of operation. Non-
compliance with this instruction reduces your engine lifespan substantially.

13.2.1 Cold starting

Turn the ignition 16 to the position I (Fig. H).
Turn the choker 17 into the position like shown in Fig. J.
Now push the button 28 3 to 5 times (Fig. K).
Pull at the cable control 20 powerfully to start the engine (Fig. M). When the engine
doesn't start you'll have to push the button some times more.
When the engine's running, you have to turn the choker 17 off again (Fig. I).

13.2.2 Warm starting

Turn on the ignition 16 (Fig. H).
Let the choker 17 turned off (Fig. F).
Do the next steps like cold starting.

13.2.3 Stopping

Turn the ignition 16 to the position O (Fig. H)
Wait till the engine stands still and all components are cold again.

13.2.4 Regulating the engine speed

For this you have to use the throttle handle shown in Fig. L.
At first you have to push the lock handle 18.
Now the throttle handle 19 can be pushed.

13.2.5 Mounting the operation attachments

For this work the engine has to stand still!
Loosen the hand screw 12.
Then push the safety cover 13 to the outside.
Push the handle being 13a under the safety cover and remove the pole with the engine.
Put the new pole with the attachment into the hole.
Push the handle again and take care that the hook at the inside of the pole fits into the
hole.
Push the cover 13 to the pole and fasten the hand screw 12 again.
Automatic Thread adjustment
Cord feed is controlled by firmly tapping the cutting head on the turf at full engine speed.
1 Run at full throttle the engine.
2 Tap the cutting head on the ground firmly, to recreate the thread. The thread we reset at every
tap of the head.
3 It may be necessary to repeatedly select, so that the cord strikes the thread diameter.
4 Continue working with the brush cutter.
Z.I.P.P.E.R MASCHINEN GmbH
Gartenpflegeset / Garden maintenance set ZI-GPS70G / ZI-GPS182G
I M P O R T A N T
www.Zipper-maschinen.at
OPERATION
Seite 46