Zipper Mowers ZI-GPS70G Betriebsanleitung Seite 40

Work attentively, safety conscious and always be fully aware safe STAND when
working!
Caution on uneven work surfaces and work surfaces with gradient-never trim
excessively steep slopes!
Avoid use in wet grass slippery!
Regular breaks the security risk reduced by loss of control due to fatigue.
Go over again the working position.
Abnormal posture avoid.
Never go running,
Trim always perpendicular to the slope, never up and down
• Never cut:
o standing on a ladder
o on trees
• WARNING: Gasoline is highly flammable!
• Before refueling, switch off engine
• Smoking and open flames are prohibited during refueling.
• Do not refuel when the engine and carburetor are still very hot.
• Refuel only outdoors or in a well-ventilated area .
• Avoid contact with skin and clothes (fire hazard) .
• After refueling, fuel cap seal well and check for leaks.
• Start the process at least 3m away from place.
• Spilled fuel is wipe immediately.
• Gasoline is kept only in specially designated containers
• If gasoline spills, no start attempt may be made . Instead, the engine of the petrol
contaminated area must be removed. Any attempt to start up to avoid volatilization
of the resulting gasoline vapors
• Damaged fuel tank or other tank caps must be replaced
• After trimming stop cock fuel close (if available).
• Remove before cutting all foreign objects (eg stones, branches, wire, etc.)
• Solid objects stones, metal parts, or the like. can be thrown out - risk of
injury!
Before the start, after the failure or shock, to check:
The device and make sure that it is in good condition.
The cutting tools for wear and damage.
The muffler.
Damaged parts must be replaced immediately!
Allow the engine never run in enclosed or confined areas.
The exhaust contains poisonous carbon monoxide. The exposure can cause
unconsciousness and death.
If the fuel tank has to be emptied, must be done outdoors this. Store the drained
fuel in a specially designed container or dispose of carefully
Z.I.P.P.E.R MASCHINEN GmbH
Gartenpflegeset / Garden maintenance set ZI-GPS70G / ZI-GPS182G
• At idle, the blade should not rotate!
• The maximum shaft speed must not exceed the specified
speed. Check settings
www.Zipper-maschinen.at
SAFETY
Seite 40