Cleaning And Sterilization; Lamp Replacement - Gima 31476 Betriebs- Und Wartungsanweisungen

5
Hold the battery handle and head in each hand and match the bayonet grooves on both the head and
handle, push the head down and turn the head clock wise.
Check that the connection between the head and handle is perfect and that the rheostat works correctly.
Push the white button on the handle and twist the black knob towards the left hand side. The unit is now in
operating position. The intensity of the light can be adjusted by turning the knob clock wise or counter clock wise.
Gently place the rubber eye brow near your eye. Then point the light beam at the center of the eye lens.
With your index finger on the lens selection dial, make use of the proper lens and note for treatment.
Switch off the unit after use to preserve batteries. Twist the black knob towards right until an audible click
sound is heard once the button comes to its off position.
Care And Maintenance
Before using, thoroughly check the product and accessories (if provided) the same operation shall be
carried out after cleaning. If the light is intermittent or in case it does not turn on, check the bulb, the
batteries and the electric contacts. In case the lamp stops working, it is possible to replace it with original
spare lamp. To replace the lamp, follow lamp replacement instructions see fig.3 also.

Cleaning And Sterilization

Lens
The lens can be cleaned by using a moistened cotton-tipped applicator with Alcohol
or a solution of water with mild detergent.
Do not use abrasive materials to clean the lenses as they will scratch
the coated surface of the lenses.
Handle
The handle can be cleaned with a moist cloth.
Battery handle shell not be dipped into water. Remove battery components while
cleaning.
Periodically check the battery condition, making sure that no sign of corrosion or
oxidation is present, in case they have to be replaced, it is highly recommended
to use new alkaline ones. For battery replacement see fig.2.

Lamp Replacement

Before removing the bulb, make sure that the instrument has been
turned off for some minutes otherwise you run the risk of being burnt.
Remove Ophthalmoscope head as advised in operating procedure (See fig.2) .
Grasp the end of lamp and pullout (use nailfile or similar object if necessary)
(See fig.3)
Insert replacement lamp by carefully aligning pin on lamp shaft with slot in
Ophthalmoscope head. Push the lamp until firmly seated.
Battery Replacement Procedure
In case of necessity replacement of new batteries then carefully handle
the batteries as the liquid in a leaking battery can irritate skin and eyes.
While replacing batteries it is necessary to
use exclusive alkaline type batteries.
a) Open the battery compartment, by turning the bottom
cap counter clock wise.
b) Once opened, insert the batteries paying attention to the
direction of poles (see fig.2).
c) To close the battery compartment, screw down the cap
clock wise and check that the batteries are in contact
with Poles.
ENGLISH
Fig. 3
Fig. 2