Wired Remote Control; Name And Function Of Each Part; Display Panel - Panasonic CS-W18BD3P Bedienungsanleitung

4. WIRED REMOTE CONTROL

4-1 Name and function of each part

AIR SWING
REMOTE
LOCAL
TEST RUN
PRE HEAT
DEFROST
TEST RUN CLOCK CANCEL
8 FILTER CLEAN
(Appears after the cumulative running time reaches
approximately 2,500 hours of operation.)
9 Operation indicator
Lights up in red when the unit is operating.
! OFF/ON button (Refer to page 7.)
" FAN SPEED button (Refer to page 7.)
# OPERATION button (Refer to page 7.)
$ TEMP (UP/DOWN) buttons (Refer to page 7.)
% FILTER RESET button
Press to reset the "FILTER CLEAN" after washing the filter.
NOTES
• Ensure that the correct button is pressed as simultaneous pressing of the multiple buttons will not make the setting correct.
• The illustration above is for explanatory purposes only. The appearance will be different during actual operation.
• Do not operate the remote control with wet hands. Otherwise, electric shock or malfunction may occur.
• Do not press the remote control buttons with sharp object as this may damage the remote control.
• Buttons marked with are not needed for normal operation. If one of these buttons is pressed by mistake, press the same
*
button once more to cancel the operation.
• When the power resumed after power failure, the unit will restart automatically with all the previous settings preserved by the
memory function. (Auto restart function)
TIMER OPE-
FAN
RATION TEMP
ON SPEED
CHECK
OFF
AUTO AUTO ADDRESS
SET
HEAT
A/C No.
FAN
LO MED HI
FILTER CLEAN
COOL
DRY
OFF / ON
TIMER
FAN OPE- TEMP
SELECT
SPEED RATION UP
SET
DOWN
FILTER
CHECK A/C No.
RESET
& A/C No. button
( CHECK button
) TIMER/CLOCK SET buttons (Refer to page 8.)
~ TEST RUN button

Display panel

1 REMOTE
The OFF/ON button cannot be used.
LOCAL
All remote control functions can be used.
2 Airflow direction setting display
3 Timer/time setting display
4 Fan speed display
5 Operation mode selection display
6 Temperature setting display (16°C – 31°C)
7 TEST RUN
Indicates that the unit is running in test operation
mode.
PRE HEAT
Indicates that the unit is running in pre-heating mode.
DEFROST
Indicates that the unit is running in defrosting mode.
*
This switch is used during group control. It is not needed for
normal operation.
Press this button if the check display is flashing. (Refer to
page 11)
*
– 6 –