Kenwood TFM400 Bedienungsanleitungen Seite 4

Only use the appliance for its intended
l
domestic use. Kenwood will not accept
any liability if the appliance is subject to
improper use, or failure to comply with these
instructions.
before plugging in
Make sure your electricity supply is
l
the same as the one shown on the
underside of your toaster.
WARNING: THIS APPLIANCE
l
MUST BE EARTHED.
This appliance conforms to EC
l
Regulation 1935/2004 on materials
and articles intended to come into
contact with food.
before using for the first time
Clip excess cord into the cord
l
storage clips in the base 1.
Operate the toaster once on a
l
medium setting without bread. (The
lever will not stay down unless the
toaster is plugged in).
As with all new heating elements,
l
your toaster may emit a slight
burning smell when it is first
switched on. This is normal and not
a cause for concern.
PREVIEW
Use the carriage lever to lift the toast
to 'Preview' at any time without
cancelling the toasting cycle.
1 slot setting, only heats what you
need, saving 50% energy.
English
key
a removable warming rack (if
supplied)
b 'Preview' carriage levers (with
'Hi-Rise™' for extra lift)
c
d bagel buttons with indicator lights
e cancel buttons with indicator lights
f browning controls
g reheat button with indicator light
h crumb trays
i cord storage
to use your toaster
1 Plug the toaster into the power
supply.
2 Turn the browning controls until the
desired setting aligns with the line up
mark on the body of the toaster. Use
a lower setting for light toasting and
for thin or dry bread.
3 Insert the bread, muffins, bagels etc.
4 Lower the lever 2 until it locks. (The
lever will not stay down unless the
toaster is plugged in). The 'cancel'
Use the carriage lever to lift the toast
l
to 'Preview' at any time without
cancelling the toasting cycle.
To stop toasting during the cycle,
l
press the 'cancel' button, the toast
will pop up and the 'cancel' button
light will go off.
5 Your toast will pop up
automatically, to raise it higher, lift
the lever.
4
button with indicator light
button will illuminate.