Getting Started - Scansonic IN210 Bedienungsanleitung

Getting Started

Carefully remove your radio from the box. You may want to keep the packaging for future use.
What you can find inside of your package
■
Main unit
■
Instruction manual
■
Power adapter
Positioning your Radio
Place your radio on a flat/stable surface that is not subjected to vibrations.
Avoid the following locations:
■
Where the radio will be exposed to direct sunlight.
■
Where the radio will be close to heat radiating sources.
■
Where the humidity is high and ventilation is poor.
■
Where it is dusty.
■
Where it is damp or there is a possibility of water dripping or splashing onto unit.
Before you use your radio, you need to know following:
Wireless LAN Setting
•
A broadband Internet connection.
•
A wireless access point (Wi-Fi) connected to your broadband Internet, preferably via a router.
•
If your wireless network is configured to use Wired Equivalent Privacy (WEP) or Wi-Fi
Protected Access (WPA) data encryption then you need to know the WEP or WPA code so
you can get the Internet Radio to communicate with the network.
•
If your wireless network is configured for trusted stations you will need to enter the Radio's
MAC address into your wireless access point. To find the Radio's MAC address use menu
items as follows: Main menu > System settings > Network > View settings > MAC
address.
Before you continue, make sure that your wireless access point is powered up and connected to
your broadband Internet. To get this part of the system working, read the instructions supplied with
the wireless access point is highly recommended.
Adjusting the Antenna
Extend the antenna to ensure you receive the best reception possible in FM radio mode. It may be
necessary to adjust the position of the radio and/or antenna to achieve the best signal.
5