Fm Mode; Selecting Fm Mode; Scan Setting; Audio Setting - Scansonic IN210 Bedienungsanleitung

FM Mode

Selecting FM Mode

1. Press MODE button repeatedly to select FM mode.
2. For initial use, it will start at the beginning of the FM frequency range (87.50MHz). Otherwise,
the last listened FM station will be selected.
3. To manually change the FM frequency, while FM frequency shows up, press VOL/TUNE
button to activate the tuning function and then turn SELECT/SNOOZE knob to change the
frequency by 0.05MHz per step.
4. To automatically scan, while FM frequency shows up, press VOL/TUNE button to activate
the tuning function and then turn SELECT/SNOOZE knob clockwise or anticlockwise, and
then press the SELECT/SNOOZE knob, your radio will skip forwards or backwards until it
reached the next available station.

Scan Setting

By default, FM scans stop at any available station. This may result in a poor signal-to-noise ratio
(hiss) from weak stations.
1. To change the scan settings to stop only at stations with good signal strength, press MENU
button, turn SELECT/SNOOZE knob to select Scan setting, and then press
SELECT/SNOOZE knob to confirm.
2. The display will show 'Strong stations only?', turn SELECT/SNOOZE knob to select 'YES',
and then press SELECT/SNOOZE knob to confirm.

Audio Setting

By default, all stereo stations are reproduced in stereo. For weak stations, this may result in a poor
signal-to-noise ratio (hiss).
1. To play weak stations in mono, press MENU button, turn SELECT/SNOOZE knob to select
Audio setting, and then press SELECT/SNOOZE knob to confirm.
2. The display will show 'Listen in Mono only?', turn SELECT/SNOOZE knob to select 'YES',
and then press SELECT/SNOOZE knob to confirm.
18