afx light SPOT100-LED Bedienungsanleitung Seite 7

Error
MT board connection failed
Pan Reset failed
Tilt Reset failed
Pan Hall failed
Tilt Hall failed
Color Wheel Reset failed
Gobo Wheel Reset failed
Focus Reset failed
ADVANCED
Password is "▲▲▲", then press the OK to enter into the Advanced Interface.
Option
Sensor Monitor
Reset Calibration
Zero Point Correction
DMX CHANNEL TABLE
CH 14 Channel Mode
1 Pan
2 Pan Fine
3 Tilt
4 Tilt Fine
5 Pan/Tilt Speed
6 Dimmer
7 Shutter/Strobe
8 Color
9 Fixed Gobo Wheel
10 Rotation Gobo Wheel
11 Gobo rotate
12 Prism
Description
The driver board did not respond. Serial communication line
connecting display panel and driver board
There is a problem, or there is a problem with the driver
board.
X-axis photoelectric switch, or problem with X-axis motor
Y-axis photoelectric switch, or problem with Y-axis motor
Pan Hall have problem
Tilt Hall have problem
Color Wheel Hall, or Color Wheel motor have problem
Gobo Wheel Hall, or Gobo Wheel motor have problem
Focus Hall, or Focus motor have problem
Description
Hall 1-6 State
Hall XY State
Pan Tilt Codewheel State
Pan Codewheel Step
Tilt Codewheel Step
Pan Calibration
Tilt Calibration
Color Calibration
Gobo Calibration
Focus Calibration
Prism Calibration
Rt Gobo Calibration
ON
www.afx-light.com
After entering the sub-interface, you
can adjust the motor such as X-axis and
Y-axis.
Reset position to compensate for errors in
hardware installation,
Adjustment range -128~+127, +0 means
no adjustment.
7 EN