First Use; Aligning The Motion Sensor - LIVARNO LUX LSHB 150 B1 Bedienungsanleitung Und Serviceinformationen

LIVARNO LUX LSHB 150 B1
 Connect the stripped wire ends of the power cable (11) using the
screw terminal (12). Make sure that the individual wires of the power
cable (11) are connected correctly. Also pay attention in this context
to the illustration [B] on the inside cover.
Wire
Black or brown
Blue
Yellow/green
 Close the cable junction box (3) by screwing the cover again tightly
with the four screws that you previously removed. A rubber seal which
is integrated in the cover ensures the sealing of the cable junction box
(3). Ensure that the rubber seal lies correctly in the groove provided in
the cover.
 Then attach the outdoor halogen spotlight to the wall bracket (7). To
do so, use the previously removed screws (2), spring washers and
nuts.
 Switch on the circuit.

8. First use

8.1. Aligning the motion sensor

Make sure that no movements that should not be detected (for
example, on the pavements or streets) occur in the detection
range of the motion sensor (8).
It is best if you set the light sensitivity of the motion sensor (8)
during the lighting conditions when the outdoor halogen spotlight
is supposed to be active.
 Align the motion sensor (8) so that it can capture the desired range as
well as possible. The view must not be obstructed by objects or anything
else.
 You can align the motion sensor (8) horizontally by turning it.
30 - English
Symbol
L
N
Designation
Phase
Neutral
Earth conductor