Samson Auro 3 Bedienungsanleitung Seite 14

Auro Installation
You can flush-mount the Auro Series
speakers on a wall using the includ-
ed ABS plastic mounting bracket.
You can position the Auro speaker
either vertically or horizontally us-
ing the flush mount bracket.
In figure 2 you can see the instal-
lation for an Auro series speaker
mounted in the vertical position.
Follow the steps below to hang your
speaker.
IMPORTANT NOTE: Only licensed
and insured professional sound
contractors should install the Auro
Speaker using the flush-mount instal-
lation brackets. Samson assumes no
liability for any installation.
• Remove the ABS plastic insert on the top and bottom of the Auro speaker.
• Slide the flush-mount brackets into the bracket channel, but don't screw
them in at this point.
• Hold the speaker in place and mark the holds for the mounting brackets.
• Now, remove the flush-mount brackets from the speaker and attach them
to the wall using the appropriate hardware, suitable for the building mate-
rial you are mounting on.
• Slide the Auro speaker into the flush-mount bracket keeping the sliding
bracket inside the top and bottom bracket channels.
• Insert the thumbscrews through the mounting bracket and into the thread-
ed inserts, and then tighten the thumbscrews all the way.
Important Note: Be careful to insert the thumbscrews straight and do not cross-
thread the thumbscrews.
Figure 2 Figure 2
10