Sony DVCAM DSBK-170 Installationsanleitung Seite 20

Installation
6
20
Note
When lowering the levers, one or both of them may not
properly seat inside the DSR-70/70P case.
If a lever is positioned as shown in the right side of the
figure below, the DSR-70/70P battery panel will not close.
Before attempting to replace the battery panel, check to
make sure that the levers are properly seated under the
board retaining rail, fully inside the DSR-70/70P case.
Push any extra slack in the harness down into the space
between boards.