Connect Power; Prepare The Remote Control; Set Clock - Philips MCM280D/12 Benutzerhandbuch

• Insert the red/blue wires to "
black wires to " -".
3
Release the socket fl ap.

Connect power

Caution
•
Risk of product damage! Ensure that the power supply
voltage corresponds to the voltage printed on the back
or the underside of the apparatus.
•
Risk of electric shock! When you unplug the AC power
cord, always pull the plug from the socket. Never pull
the cord.
•
Before connecting the AC power cord, ensure you
have completed all other connections.
1
Connect the power adapter to
• the DC IN jack on the rear of the
main unit
• the power socket.

Prepare the remote control

Caution
•
Risk of explosion! Keep batteries away from heat,
sunshine or fi re. Never discard batteries in fi re.
For fi rst-time use:
1
Remove the protective tab to activate the
remote control battery.
To replace the remote control battery:
1
Open the battery compartment.
2
Insert one CR2025 battery with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
10 EN
+",
•
Before pressing any function button on the remote
control, fi rst select the correct source with the remote
control instead of the main unit.
•
If you are not going to use the remote control for a
long time, remove the battery.

Set clock

1
In standby mode, press DISPLAY/
CLOCK to activate the clock setting
mode.
»
•
In Eco Power Standby mode, press
clock fi rst, then press and hold CLOCK to proceed
clock setting.
2
Press
24 hour format.
3
Press VOL +/- to set the hour.
4
Press DISPLAY/CLOCK to confi rm.
»
5
Press VOL +/- to set the minute.
Note
The hour digits are displayed and begin
to blink.
Note
repeatedly to select 12 hour or
The minute digits are displayed and
begin to blink.
CLOCK to show