oneConcept 10029361 Bedienungsanleitung Seite 15

Preparation and Wall Mounting
• irst push to inside as the direction indicated by the arrow (See 1) and then Remove the
battery holder as the direction indicated by the arrow (See 2).
• Replace the battery Set a new battery property with (+)side up as illustrated (See 3).
• Insert the battery holder. Push in the holder to the original position (See 4).
Using the Remote Control
Face the remote control towards the player front face IR mark (remote control signal receiver).
Operation angle: About 30 degree in each the direction of the front of the IR mark.
Note: The lithium cell in the battery compartment of remote control has been secured for
transport with a foil. Before initial use please remove this foil so that the remote control is
ready for operation.
Turn the unit over as shown below, and align the mounting blocks on the top of the stand, with
the mounting openings located on the bottom of the main unit. Once in place, the 4 mounting
tabs on the stand will align with the 4 rectangular mounting slots located on the bottom of the
unit. Make sure the mounting tabs are lined up with the slots, and slide the stand towards the
front of the unit until the mounting stand it is fully inserted, and locked in place. Make sure the
base is locked firmly in place, so it does not come off.
To remove the stand, use both hands to hold the stand, and using two fingers, lift the two locking
tabs marked with arrows to unlock the base. Slide the stand towards the back of the unit to un-
lock. When the stand is in unlock position, pull the stand upward to remove it.
Preparing the Remote Control
Attaching the Stand
15