HANSGROHE Raindance Duschpaneel 27005000 Montageanleitung Seite 27

Fault
Insufficient water
Crossflow, hot water being forced
into cold water pipe, or vice
versa, when mixer is closed
Spout temperature does not corre-
spond with temperature set
Temperature regulation not pos-
sible
Safety stop button not operating
On/off control stiff
English
Cause
- Supply pressure inadequate
- Regulator filter dirty
- Shower filter seal dirty
- Backflow preventers dirty or leak-
ing
- Thermostat has not been ad-
justed
- Hot water temperature too low
- Temperature regulator dirty or
calcified
- Spring defective
- Button calcified
- Cartridge on/off control defec-
tive, calcifiedt
Remedy
- Check water pressure (If a pump
has been installed check to see if
the pump is working).
- Clean filters
- Clean filter seal between shower
and hose
- Clean backflow preventers, ex-
change if necessary
- Adjust thermostat
- Increase hot water temperature
to 42 °C to 65 °C
- Clean temperature regulator, ex-
change if necessary
- Clean spring and/or button, ex-
change if necessary
- Exchange cartridge on/off con-
trol
7