urmet 1092 Schnellanleitung Seite 4

ENGLISH
INSTALLATION
1. Before installation, make sure that all devices to be connected are not powered.
2. Place the bracket base on the supporting surface to mark the 4 fixing holes. Consider the position of
the slot placed on the bracket, used for the passage of the cable (see photo). Use the base as drilling
template.
3. Fix the camera and the provided suitable spanner, taking care to place the cable on the seat present
in the bracket, in order to avoid pinching the cable.
4. Place the bracket in a position suitable for shooting the selected images; the camera can be adjusted
on the HORIZONTAL and VERTICAL axis.
HORIZONTAL AND VERTICAL ADJUSTMENT
•
Loosen the ring on the bracket and the adjusting screw shown in the figure.
•
Point the camera at the desired position
•
Once the adjustment has been performed, tighten the screw with the grub screw and the suitable
spanner
Important! Don't use the screw placed on the other side of the camera
5. Connect the video output to the selected terminal device.
6. Connect the terminals (+/-) of the RS-485 connector to a control keyboard (e. g. 1092/693) for camera
control and programming (all the parameters can be managed by a keyboard). Terminate the last
device of the line with a 120 ohm resistor. In case of long and/or underground cables, protect the
device with a dedicated filtering device (e.g. Urmet Ref, 1092/732).
7. Power the camera. Unscrew the screw on the bottom of the camera to access to the adjustment
screws and to the OSD menu button.
4
ADJUSTING SCREW
DS1092-224