Installing The Ear Speaker And Microphone; Connecting Ear Speaker And Microphone To; Interphone Headset; Getting Started - Cellular Line BTEASYCOM Bedienungsanleitungen

BTEASYCOM

3. installing the ear speaker and microphone

Now you need to attach the ear speaker and micro-
phone arm to the inside of the helmet . Take the velcro
which the ear speaker will attach to, and test for the best
position to fix it . The velcro should be fixed at the height
of your ear . You will need to put the helmet on a few
times to find the optimum position . When the correct
positioning is found, remove the protective strip and
apply the velcro .
Next, take the ear speaker and attach it to the velcro .
Run the microphone arm down along down to where
your mouth will be . As the microphone arm is flexible,
you can adjust it so it sits in the optimum position in
front of your mouth .
note: There are two types of velcro, thin and thick .
Please use based on the actual situation .
4. Connecting the ear speaker and microphone to

interphone headset

Take care to connect USB cable to the USB port of inter-
phone headset, now you have successfully installed the
interphone .
18

- getting started

1. Charging the interphone headset

The Bluetooth® interphones have built-in rechargeable
batteries, prior to using them, it is recommendable to
charge their batteries fully for the first time .
Connect one end of USB cable to a standard power out-
let and the USB plug to the USB port of the interphone
headset . The red LED will be on while charging . It takes
about 2 hours to charge the battery fully . When charg-
ing has completed, the red LED will be off .
When the Bluetooth® interphone is on and the battery
becomes low, the red LED flashes and the Bluetooth®
interphone emits 3 "DU" tones every 30 seconds . Please
recharge the battery fully as described above .
notes:
1) When you can't turn off the Bluetooth® interphone,
you can turn it off as soon as you charge it .
2) There is travel charger .
Warning:
1) The battery is recyclable .
2) Batteries (battery pack or batteries installed) shall not
be exposed to excessive heat place such as sunshine,
fire or the like .