EN
SWITCH-OFF TEMPERATURE SETTING
A The switch position for switch-off at 85°C
B The switch position for switch-off at 100°C
CAUTION:
Prior to first use, we recommend boiling the maximum volume of water in the kettle at least 3 times, then pouring it
out. The kettle is then ready for operation.
The kettle may only be used with the supplied base.
OPERATING INSTRUCTIONS
1. Remove the kettle from the base (7), press the button for opening the lid (3), open
the lid (1), fill the appliance with cold water within the permitted maximum
only. If the water level in the kettle is under the recommended minimum, the
kettle will keep overheating and turning off prematurely.
Note: Make sure that the lid (1) is closed properly, otherwise the kettle can not
turn off automatically
2. Place the kettle on the base (7); electric contacts will get connected automatically.
Thanks to the central connector design (Fig. 1), the kettle can turn around 360°
and be put on the base from any side.
3. Connect the base to the mains.
4. Select the kettle automatic turn-off temperature you require by shifting the
switch (6) to the left position for heating coffee water (85°C), or to the right one
for heating tea water (100°C).
5. Turn the kettle on by pressing the switch (6).
A control light on the switch (6) signals the kettle is in operation. The kettle lid (1)
must be properly closed when water is being heated.
WARNING!
Do not open the lid during heating and immediately after heating is over. Hot
steam could scald you!
6. When the preset temperature is reached, the kettle turns off automatically and
the operation indicator light goes off. You can interrupt heating water any time by
turning off the switch (6).
7. Remove the kettle from the base (7) and use the hot water.
8. If you want to reheat the water you have just finished boiling, wait for approximately
30 seconds before reactivating the switch (6).
9. The kettle filter captures all potential impurities while pouring water.
RK2230
A
B
Obr. 1
Fig. 1
19