SPL-Technik SPL 163 Bedienungsanleitung Seite 9

Flight practice
Landing
Perform hovering, then smoothly reduce the rotation of the rotors. The model will
begin to descend. Don't cut the rotations too sharply, because if the rotors stop the model
will inevitably fall to the ground. This can result in damage to the model.
ATTENTION!
If the helicopter battery is discharged or the helicopter is used for a long time, the
power can automatically cut off. When this happens, the indicator on board the helicop-
ter twinkles and the helicopter is inactive. This is a normal occurrence with this model.
In case of automatic power cut-off due to lengthy use of the helicopter, move the gas
stick to the minimum position, switch off the helicopter's power, charge the on-board
battery and then switch on again: your helicopter will again be ready to fly. Attention! If
the gas stick is not in the minimum position, then the helicopter will immediately take off.
The flickering red indicator on the helicopter's control board tells you the transmitter
batteries are low. Change the batteries and resume flying.
8