SPL-Technik SPL 163 Bedienungsanleitung Seite 7

Important: if the helicopter is always rotating, please use
If the helicopter rotates during flight, follow the instructions below to stop the rotation.
The helicopter rotates counter clockwise.
Adjust the trimmer until the helicopter stops rotating.
The helicopter rotates clockwise.
Adjust the trimmer until the helicopter stops rotating.
Flight practice
Hovering is when the helicopter maintains an unchanged position in the air. This
manoeuvre must be mastered well.
Slowly raise the helicopter to a height of 30-40 cm. If the model is moving in one
direction or another, carefully move the respective control stick in the direction opposite
to the direction of the model so as to return the helicopter to the starting position.
Draw a circle on the floor and try to keep the helicopter inside this circle. Once you
have mastered hovering in place, move on to executing figures. Begin by flying a square
route: a 'box'. Then do a figure-eight as shown in the illustrations. As soon as you master
these manoeuvres, try to repeat them in the reverse direction.
the trimmer to adjust the rudder.
Turn the trimmer clockwise.
Turn the trimmer counter clockwise.
7