SPL-Technik SPL 163 Bedienungsanleitung Seite 6

Preparation for flight
1. Charge the model and insert fresh
batteries in the transmitter.
2. Turn on the power of the transmitter.
3. Move the helicopter's power switch to the ON position.
The indicator on board the helicopter should flicker brightly.
4. Place the helicopter on an even surface in front of you.
5. Be sure that the distance between you and the helicopter is around 2 metres.
6. Wait until the indicator on the model stops flickering. Now you can take off smoothly
by moving the gas stick upwards.
Flight and manoeuvres
Important: only small and smooth changes in the position of
the sticks ensure stable flight of the helicopter.
Smoothly move the left stick upwards
Up
(away from yourself)
Down
Smoothly move the left stick back
(towards yourself)
Forward
Smoothly move the right stick forward
(away from yourself)
Back
Smoothly move the right stick back
(towards yourself)
Turn to the
Smoothly move the right stick to the
right
right.
Turn to the Smoothly move the right stick to the
left
left.
Controls for
To switch the on-board lights on or off,
the on-board
press the upper button on the lower
lights
right side of the transmitter
Accelerator
To switch the accelerator function on or off, press
controls
the lower button on the lower right side of the
transmitter. In acceleration mode, the helicopter
accelerates to maximum speed.
In order for the helicopter to move to the left,
Bank to the left
move the left lever of the transmitter to the left
or depress the button on the upper left side of
the transmitter.
In order for the helicopter to move to the right,
Bank to the right
move the left lever of the transmitter to the right
or depress the button on the upper right side of
the transmitter
6