SPL-Technik SPL 163 Bedienungsanleitung Seite 4

Safety rules
4. When cleaning the model, do not use solvents. This can cause damage to the plastic
parts of the model.
5. It is recommended that you fly the model in spacious premises. This model is not
intended for flying outdoors.
6. Do not fly the model in places where people, especially children, are gathered, and
stay at least 15 metres away from devices which could interfere with the flight of the
model. Make sure that there are no foreign objects with which the model could collide.
7. Don't let the model fly too far away from you. The farther away it is, the more difficult
it is for you to correctly judge its position and behavior in flight.
8. Always point the optical sensors of the transmitter directly at the model.
9. Powerful radio signal sources can significantly influence the quality of transmitter
reception.
10. When learning how to fly, it is recommended that you make flights at low altitude. In
case of pilot error, you can then easily reduce the gas and lessen the risk of serious
damage to the model.
11. In case of unforeseen emergencies or collision with some obstacle, immediately
switch off the engine. Never turn on the model if something obstructs the rotation of the
rotors.
12. Minimum dimensions of the premises used for flying: 5x5x3 metres, without any
draughts and directional air flows.
13. Take off only from a flat and smooth surface, starting out slowly and gradually raising
the rpms of engine.
14. Never hold the model with rotating rotors at the level of your face.
15. Always look at the model; don't concentrate attention on the transmitter.
16. Don't stand behind objects which could prevent you from quickly going up to the
model.
17. Watch closely the direction and height of the flight; always compensate for any
deviation from the intended direction of flight by small and steady movement of the
transmitter sticks. The main error of beginning pilots is jerky movement of the sticks in
extreme positions – this always leads to loss of control and to the model's falling down.
18. Trim the model before each flight.
19. Never grab the model by rotor parts.
20. Always switch off the model's power, even if the rotors have stopped automatically.
21. Never close and do not tape down the transmitter emitter.
22. Never tape onto the model additional parts or stickers.
23. Don't let children start up the model without adult supervision.
24. Never start up the model if it has damaged parts.
25. Do not disassemble and do not make alterations in the model's construction.
Parts of the helicopter's power supply
1. Helicopter battery (installed on board) – 3.7V 800mAh
2. Power supply parts of the transmitter: 4 АА 1.5V batteries (not included).
4