SPL-Technik SPL 163 Bedienungsanleitung Seite 5

Installation of the transmitter batteries
1. Open the lid of the battery compartment, put in place the 6 AA
batteries
(not included in kit), being sure that the polarity is correctly aligned.
2. Close the lid of the battery compartment.
Installing the antenna in the transmitter
Insert the antenna in the corresponding socket on the transmitter.
Rotate the antenna clockwise to the end.
Charging the helicopter
The red wire
is plus (+)
The black wire
is minus (-)
Turn the power supply switch of the helicopter to the OFF position.
Plug the charging device into the socket. The indicator on the charging device will glow
with a green light. Disconnect the battery plug from the helicopter and connect it to
charging device plug as shown in the illustration. Respect the polarity. If everything is
properly connected, the indicator on the charging device will light up red and the charging
process will begin. The charging time is about 150 minutes. When the battery is fully
charged, the indicator on the charging device will again light up green. Your helicopter is
ready for flight.
The model helicopter is equipped with an in-built lithium polymer battery. When using
it, you must observe the following safety rules:
1. Don't let the batteries fall from heights.
2. Don't expose the batteries to blows on hard surfaces.
3. Don't throw the batteries into a fire or into water and store them in a dry place.
4. Use only the original charging device.
5. Don't disassemble the battery.
6. Don't leave the battery unsupervised when charging.
5