Specifications - Emos P4521 Handbuch

1450000200_31-P4521
GB
Rechargeable LED Lantern - E4024D-6

Specifications

The rechargeable lamp is resistant to rough conditions (dust, dirt) and is therefore suitable for technicians, handymen and
cottagers, as well as for use in the car. The lamp is fitted with 3 powerful magnets and 2 break-resistant nylon hooks for hanging.
The bottom portion of the lamp can be rotated 180°. The lamp can be used continuously with a fully charged accumulator for
approximately 3.5 hours with SMD LED and 7.5 hours with 1 W LED. The lamp can be charged, or recharged, from a 100–240 V~,
50/60 Hz network or from a car socket with 12/24V=. The lamp can be used while the accumulator is recharging.
1
2
3
Specifications:
Light source
Accumulator pack
Network power supply
input
output
Recharging from car
Power source for car
Recharging the Accumulator
The lamp must be charged before first use or if the lamp does light up anymore. The lamp indicates that the accumulator is flat
by flashing (the lamp will flash for approximately 5 minutes); then the lamps turns off completely. Recharging a fully discharged
accumulator pack takes approximately 4–5 hours (the recharge time depends on how depleted the accumulator is). Recharge
the lamp in dry indoor areas.
1. Connect the network power adapter (type TEKA006-0501000EUU) to a 100–240 V~, 50/60 Hz network.
2. Turn the switch on the lamp to the off position.
3. Connect the network power adapter into the lamp's power connector – a red light will turn on on the lamp. When the lamp
(accumulator) is fully recharged, the LED will turn green.
4. After recharging, disconnect the adapter from the lamp.
The accumulator can be recharged intermittently – it has no memory effect.
The lamp can also be recharged in a car – 12/24 V= through the lighter socket. Procedure for plugging in and recharging is
similar as when using a network adapter. After recharging, disconnect the car adapter. The lamp can be recharged using a
car adapter only when the vehicle is stationary and the engine is turned off. Do not under any circumstances charge
the lamp when the car engine is running or the car is in motion.
The LED light sources have a 50,000 hour service life and therefore need not be recharged. After exhausting, the entire lamp
can disposed of.
148×210 mm
4
7
5
6
7
4
3 W (6× 0.5 W) SMD LED (320 lm) + 1 W LED (80 lm)
Li-Ion 18650 – 3.7 V=/2 200 mAh
type TEKA006-0501000EUU;
100–240 V~ 50/60 Hz, max. 0.3 A
5 V=/1 000 mA
12/24 V=
adapter, input: 12/24 V=, output: 5 V=/1 000 mA
1. 1 W LED
2. 3 W (6× 0.5 W) SMD LED
3. Switch
4. 2× nylon hook, 360°
5. Socket for charging – micro USB
6. LED recharge indicator
7. 3× magnet
8. Turning handle, 180°
8
2