Cleaning And Maintenance - KikkaBoo UNIVERSAL Gebrauchsanweisung

• All seat cover on the restraint are removable for cleaning. You can simply blot the desired area with a damp sponge and cool water.
• Your child restraint should not be purchased or sold as a secondhand item. It is recommended not to use child restraint older than 6
years as the protection in an accident may be reduced.
HARNESS ADJUSTMENT: This car seat has 2 sets of slots. Select the suitable slots according to child's physique. To change the harness
strap position, undo the harness strap from the seat buckle, come out from belt slots on the back of car seat and re-thread them through
the desired slots. Reconnect the straps to seat buckle (Figure 3).
HANDLE ADJUSTMENTS: Face the restraint: push the red button on each side of handle, rotate and release red button to desired position
until hearing a „click". Four positions are available. IMPORTANT: Before lifting car seat, place handle in „ locked" upright carrying position
(Figure 4).
INSTALATION (Figure 5)
1. Place the car seat REAR-FACING on vehicle seat.
2. Thread vehicle lap belt through car seat SLOTS and buckle belt. NOTE: Vehicle shoulder belt must not be place through car seats slots.
3. Pull front to back and left to right to check for secure installation. NOTE: Vehicle MUST be on level ground and child in car seat when
le veling.
PLACE YOUR CHILD IN THE RESTRAINT (Figure 6)
1. Press the red release button on buckle, unfasten the buckle connector 1 & 2.
2. Lift up the harness straps and lay them flat on the back of restraint.
3. Place your child in restraint. Note: Do not place your child in a sleeping bag, blanket or other bulky wrapping before putting child in the
restraint. The shoulder straps will not fit snugly and the child won't be safe.
4. Put the harness straps on each side of child, s shoulder. Remark: A newborn baby will need extra support around the head and body.
Please don't remove the cushion if you are going to use it of your newborn baby or baby less than 7 months. he cushion is alternative
item, please asking sell agent regarding to this extra selection.
5. Join the two buckle connectors, passing the left under the right, and inserting them both into the buckle until you hear a „click"
signifying the buckle is locked.
6. Pull the harness adjuster lock to the position you desired.
7. Check that harness straps are snug with just enough room to insert one finger between child s Chest and harness straps. Note: check
that the buckle is secured by attempting to pull the above and below part to remove the connectors.
TAKE YOUR CHILD OUT OF RESTRAINT THEN REMOVE THE RESTRAINT OUT OF VEHICLE
1. Press the red release button on buckle, unfasten the buckle connector 1&2.
2. Lift up the harness straps and lay them flat on the back of restraint.
3. Take your child out of restraint.
4. Unbuckle the vehicle seat belt.
5. Pull out the vehicle seat belt through the seat belt hooks in the restraint.
6. Remove the restraint out of vehicle.

CLEANING AND MAINTENANCE

For quickly clean up, simply blot the desired area with a mild soap solution using a damp sponge and cool water, if necessary can be
hand washed.
• Clean up your car seat shell with mild solution soap and cool water. Never use„household detergents": they can weaken plastic.
• Harness straps are only surface washable with mild soap and damp cloth.
• Don't use machine washing.
• Don't use hot water to wash.
ENGLISH