Herunterladen Inhalt Inhalt Diese Seite drucken

Daily Use - Electrolux EDH3684PDW Benutzerinformation

Vorschau ausblenden Andere Handbücher für EDH3684PDW:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

24 www.electrolux.com
Adjusting the conductivity sensor
1. Use the programme knob to set any
programme.
2. Press and hold touchpads (A) and (B)
at the same time until one of the these
indicators comes on:

7. DAILY USE

Before you use the appliance for
the first time do one of these op-
erations:
• Clean the tumble dryer drum
• Start a short programme (e.g.
At the beginning of drying cycle
(3-5 min.) there could be a slightly
higher sound level. It is because of
start of the compressor that is
normal for compressor powered
appliances such: refrigerators,
freezers .
7.1 Starting a programme
without delay start
1. Prepare the laundry and load the ap-
pliance.
2. Set the correct programme and op-
tions for the type of load.
• The display shows the programme
duration.
3. Press the Start/Pause touchpad, the
programme starts.
CAUTION!
Make sure that when you close
the door, the laundry does not
catch between the appliance door
and the rubber seal.
7.2 Starting the programme with
delay start
1. Set the correct programme and op-
tions for the type of load.
(low <300 μS/cm)
(moderate 300-600 μS/cm)
with a moist cloth.
30 minutes) with moist laundry.
(high >600 μS/cm)
3. Press the touchpad (E) again and
again until the indicator of the correct
level comes on.
4. To confirm the adjustment, press and
hold touchpads (A) and (B) at the
same time for approximately 2 sec-
onds.
2. Press the delay start button again and
again until the display shows the delay
time you want to set.
• You can delay the start of a pro-
gramme from a minimum of 30 mi-
nutes to a maximum of 20 hours.
3. Press the Start/Pause touchpad, the
countdown starts. The display shows
the countdown of the delay start.
• When the countdown is completed,
the programme starts.
7.3 Change a programme
1. Turn the Programme knob to
2. Set the programme.
7.4 At the end of the
programme
When the programme is completed,
• An intermittent acoustic signal oper-
ates.
• The indicator
flashes.
• The indicator
comes on.
• The Start/Pause indicator is on.
The appliance continues to operate with
the crease guard phase for approximately
other 30 minutes.
The crease guard phase removes creases
from your laundry.
You can remove the laundry before the
crease guard phase is completed. We
recommend, for better results, that you
remove the laundry when the phase is al-
most completed or completed.
When the crease guard phase is comple-
ted:
• The indicator
is on but does not flash.
OFF

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis