Installation - Black+Decker NVB215WN Dustbuster Bersetzung Der Ursprünglichen Anweisungen

ENGLISH
#
This tool is double insulated;
therefore no earth wire is
required. Always check that the
power supply corresponds to
$
the voltage on the rating plate.
The charging base is intended
for indoor use only.
Labels on appliance
The following symbols appear on this appliance along with the
date code:
Only use with charger _A035015D
_A035015D
Features
This tool includes some or all of the following features.
1. On/off switch (press and hold)
2. Bowl release button
3. Dust bowl
4. Charger
5. Charging bracket
Fig. A
6. Dry pick up cloth filter
7. Pre-filter
Fig. B
11. Brush tool (WA units Only)
12. Crevice tool (WA units Only)

Installation

Wall Mounting (fig. C)
The product can be attached to a wall to provide a convenient
storage and charging point for the appliance.
When fixing to a wall, make sure that the fixing method is
suitable for the wall type and is appropriate to the weight of
the appliance.
Mark the location of the screw holes (within reach of an
u
electrical outlet for charging the vac while it is on the wall
bracket).
Fix the mounting bracket to the wall using appropriate
u
screws and plugs for the type of wall and weight of the
appliance.
Hang the appliance on the wall by placing the opening
u
on the base of the vac over the hooks in the wall mount
charging bracket.
6
(Original instructions)
Assembly
Accessories (fig .B)
These models may be supplied with some of the following
accessories:
A brush tool (11) for furniture and stairs.
u
A crevice tool (12) for confined spaces.
u
Fitting (Fig. D)
Insert the appropriate accessory into the front of the appli-
u
ance. Make sure that the accessory is pushed fully in.
Use
Before first use, the battery must be charged for at least
u
24 hours.
Place the appliance on the charging bracket whenever it is
u
not in use.
Warning! Never pick up wet applications with these units.
Charging the battery (Fig. C)
Make sure that the appliance is switched off. The battery
u
will not be charged with the on/off switch (1) pressed.
Place the appliance on the charging bracket (5).
u
Plug in the charger. Switch on at the mains.
u
Leave the appliance to charge for at least 21 hours.
u
While charging, the charger may become warm. This is
normal and does not indicate a problem. The appliance can
be left connected to the charger indefinitely.
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C.
Switching on and off (fig. E)
To switch the appliance on, press and hold the on/off
u
switch (1).
To switch the appliance off, release on/off switch (1).
u
Dry pick up
For everyday spills of dry material.
u
Warning! Never pick up wet applications with these units.
Optimising the suction force
In order to keep the suction force optimised, the filters must be
cleared regularly during use.
Emptying and cleaning the product.
Removing the dust bowl and filters (fig. F & G).
Warning! The filters are re-usable and should be cleaned
regularly.
Press the bowl release button (2) and pull the dust bowl
u
(3) straight off.