Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Indication of the channel: It is possible to have the channel indication (1 to 16) displayed instead of the frequency:
simply press the "function" button briefly.
To select between mono and stereo operation, simply press the MONO/STEREO button on the front panel. The LCD
will momentarily display the word "MONO" when this mode is selected. Pressing the button again will reset the
transmitter in STEREO mode and the speaker symbol will light up on the display.
To protect against unintentional programming, if no button is pressed to store the new setting, the unit will return to the
last stored setting after approximately 8 seconds.
Receiver
Please note that it is strongly advised that the earpieces are UNPLUGGED during programming. This will protect the
user from any noises caused by setting to an already busy frequency.
Insert a fresh alkaline battery into the receiver and switch the unit on. After a couple of seconds you will see the last
selected frequency displayed.
Programming must be made operating the two push buttons placed under the LCD
The left button is used for "mode" and "enter" whilst the right button is used as "select"
Pressing the left button will allow you to scroll through the following modes. The right button selects the options for the
currently selected mode:
Frequency select. This allows you to scroll through the frequencies
Channel select. Choose from 16 channels.
HL. This function allows the headphone limiter to be de-selected as may be
applications. The limiter is to protect against distortion which
program. We therefore strongly
Stereo. This allows individual receivers to operate in mono regardless of whether
in mono or stereo.
Storing your changes
When you are happy with you new selection, do not press any button but wait for 5 seconds until you see the word
"Store" appear. Now press the left button and the word "stored" will appear momentarily.
Your new setting has now been activated.
Pressing the right button during the store process will cause the word "Abort" to appear in the display. Pressing the
right button again will revert to "store". If you want to abandon your changes press the left button when "Abort" is
displayed.
To protect against unintentional programming, if no button is pressed to STORE the new setting within 8 seconds, the
unit will return to the last stored setting.
Licensing
18
recommend that the HL is always set to ON.
Don 't get distracted during programming !
may be caused by unexpected transients in the audio
required in certain
the transmitter is operating
Werbung
