Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The following items are necessary for operating the system. These are included in the carton.:
l. IEM 2000T Stereo Transmitter
2. Transmitter aerial
3. a.c power supply - *Check this is the correct voltage for your country*
4. IEM 2200R Stereo Receiver complete with integral aerial
5. Operating manual and warranty card
Please inform your supplier immediately if any of the above items are not present.
Features
Transmitter
3 groups each with 16 pre-programmed frequencies for maximum flexibility*
Free run mode allows any frequency in the band to be selected*
Large LCD displays operating frequency, input level and mono mode when selected
Easy setting of operating frequency and stereo or mono mode via push buttons
Neutrik Combo™ connectors allow connection via ¼" jack or XLR connectors
Link sockets allow easy connection onto other line level equipment
Dual input level controls for individual adjustment of left and right signals
Variable ratio limiter for subtle control of program transients
Monitor section with both ¼" and 3.5mm stereo sockets
Receiver
3 groups each with 16 pre-programmed frequencies for maximum flexibility*
Free run mode allows any frequency in the band to be selected*
Easy setting of operating frequency, stereo or mono operation
LCD displays operating frequency, RF signal strength and battery status
Top panel finger adjust of left-right balance or mixing of left & right signals
Switch to select between stereo or mix modes
Soft mute system prevents clicks or pops in areas of poor reception
Slim and lightweight case can be easily concealed in a pouch or pocket
Featured with a very wide dynamic range and an extremely good signal to
The very low current consumption allows very long operating life
The available audio output power is high enough to satisfy any professional need
*This feature may not be available in all countries - please check with your dealer
Setting up
Transmitter
Warning- Use only the supplied a.c. to a.c. adapter plug. Using a different type could cause permanent damage to the
transmitter
The transmitter features Neutrik Combo™ connectors for left and right inputs, allowing connections via ¼" stereo jack
or standard XLR connectors. The transmitter also features "link" sockets which will allow another IEM 2000T
transmitter, amplifier or any line level device to be connected to the same feed. This is especially useful where only
one monitor send is available from the mixing console.
Connect the aerial onto the front panel socket, taking care to align with the location pips on the socket. Remember to
turn the plug 1/4 turn clockwise to lock the aerial into position.
Connect the audio signals at a nominal OdBV into left and right inputs
Plug the supplied a.c. adapter into the transmitter and then into the wall outlet.
Make sure the input level control is set to minimum and then switch on the transmitter.
Check the LCD display is showing the desired operating frequency then send a stereo signal at around 0 dBV. (The
section Programming explains how to change the operating frequency)
15
noise ratio
16
Werbung
