Cognex In-Sight 9000 Series Handbuch Seite 13

Connect the Ethernet Cable
CAUTION: The Ethernet cable shield must be grounded at the far end.
Whatever this cable is plugged into (typically a switch or router) should have a
grounded Ethernet connector. A digital voltmeter should be used to validate
the grounding. If the far end device is not grounded, a ground wire should be
added in compliance with local electrical codes.
1. Connect the Ethernet cable's M12 connector to the vision system ENET
connector.
2. Connect the Ethernet cable's RJ-45 connector to a switch/router or PC, as
applicable.
Connect the Breakout Cable
CAUTION: To reduce emissions, connect the far end of the Breakout cable
shield to frame ground.
Note:
Perform wiring or adjustments to I/O devices when the vision system
l
is not receiving power.
You can cut exposed wires short or trim wire ends. You also can tie
l
the wires back if you use a tie made of non-conductive material. Keep
bare wires separated from the +24VDC wire.
1. Verify that the 24VDC power supply is unplugged and not receiving power.
2. Optionally, connect the I/O wires to an appropriate device (for example, a
PLC or a serial device).
12