Dismantling And Disposal - Giona ECOSYN 190-300 Installations-, Bedienungs- Und Wartungsanleitung

2 - RESIDUAL RISKS / DISPOSAL
DISPOSAL
CE WEEE DIRECTIVE
The manufacturer is registered on the
EEE National Register, in compliance with
implementation of Directive 2012/19/EU
and relevant national regulations on waste
electrical and electronic equipment.
This Directive requires electrical and
electronic equipment to be disposed of
properly.
Equipment bearing the crossed-out
wheelie bin mark must be disposed of
separately at the end of its life cycle to
prevent damage to human health and to
the environment.
Electrical and electronic equipment must
be disposed of together with all of its
parts.
To dispose of "household" electrical and
electronic equipment, the manufacturer
recommends you contact an authorised
dealer or an authorised ecological area.
"Professional" electrical and electronic
equipment must be disposed of by
authorised personnel through established
waste disposal authorities around the
country.
In this regard, here is the definition of
household WEEE and professional
WEEE:
WEEE from private households: WEEE
originating from private households and
WEEE which comes from commercial,
industrial, institutional and other sources
which, because of its nature and quantity,
is similar to that from private households.
Subject to the nature and quantity, where
the waste from EEE was likely to have
been by both a private household and
users of other than private households, it
will be classed as private household
WEEE;
Professional WEEE: all WEEE which
comes from users other than private
households.
This equipment may contain:
refrigerant gas, the entire contents of
which must be recovered in suitable
containers by specialised personnel with
the necessary qualifications;
• lubrication oil contained in compressors
and in the cooling circuit to be collected;
• mixtures with antifreeze in the water
circuit, the contents of which are to be
collected;
• mechanical and electrical parts to be
separated and disposed of as authorised.
When machine components to be
replaced for maintenance purposes are
removed or when the entire unit reaches
the end of its life and needs to be
removed from the installation, waste
should be separated by its nature and
disposed of by authorised personnel at
existing collection centres.

Dismantling and disposal

THE UNIT MUST ALWAYS BE SENT TO
AUTHORISED CENTRES FOR
DISMANTLING AND DISPOSAL.
When dismantling the unit, the fan, the
motor and the coil, if operating, may be
recovered by the specialist centres for
reuse. All the materials must be recovered
or disposed of in compliance with the
corresponding national standards in force.
For further information on the
decommissioning of the unit, contact the
manufacturer.
10