Using The Radio For The First Time; Setting The Clock Time; Operating Your Radio - Fm - perfect pro ROCKMATE-2 Bedienungsanleitung

Using the radio for the first time

1. Place your radio on a flat surface.
. Please press the Standby button to switch on your radio. It may be necessary to relocate your
radio to a position giving better reception. You should then carry out a scan to find stations in FM.

Setting the clock time

1. Press and hold the Tuning knob until the hour digits of the clock time begins flashing. Rotate
the Tuning knob to choose the hour digit as needed.
. Press and release the Tuning knob to save the hour setting, and the minute digits on the display
will flash. Rotate the Tuning knob to choose the minute digits as needed.
. Press and release the Tuning knob to save the minute setting and complete the clock setting.
The radio will save your setting. The radio will display saved time after clock time setting is
completed.
Note: The clock time setting can be done at power Off or On status.
You can also set the clock time with the FM RDS. This can automatically set the time (CT) Press
the source to FM radio, select a FM radio station which provides RDS CT service, the clock will
be aligned in  minutes once the CT service is available. Once the FM radio station has been
changed to one with RDS CT service, the clock time will be aligned again.
Operating your radio – Manual tuning FM
. Press the STANDBY button to switch on your radio.
. Press the SOURCE button to select FM band and stand up the rubber antenna properly to get
best FM reception.
. Rotate the Tuning/Seek knob to tune required frequency in the increment of 00 kHz.
4. Select required loudness setting and stereo / mono mode for obtaining a best sounding quality.
5. A stereo symbol will appear on the LCD display if a stereo broadcasting station is found.
6. Rotate the Volume control knob to get required sound level.
7. To turn off the radio, press the STANDBY button. Display will show local time only.
9
1-3
1,7
2
3
6