oneConcept Multidesk Comfort 10034474 Originalbetriebsanleitung Seite 13

EN
Lifting columns cannot operate.
If the desk doesn't work, after confirming the control panel works properly,
please turn the power off, and restart the system. If it still
doesn't work, please contact your point of purchase for service or repair to
your unit.
0vercurrent protection
In addition, an over-current protection mode has been also programmed in
this system. When the electricity is over rated specification,
the system will enter this mode. The desk will lower approximately 30mm
and stop with the height displayed if the mode activates. This
is only an introduction of the function of the downward movement. No
trouble shooting is required when this happens.
13