oneConcept Multidesk Comfort 10034474 Originalbetriebsanleitung Seite 11

EN
Memory Selling: Adjust the desk to your desired position. Press the "M"
button, then "S-" appears on the display. Press "1", "2" or "3".
The memory is successfully set. You can store up to 3 heights by repeating
the same process.
Protective Standby Mode: If there is no operation for 1 minute, the system
will enter the protective standby mode. To turn off the standby mode, press
and hold the "M" button for 3 seconds. You can also press and hold the "M"
button for 3 seconds to activate the standby mode, when you don't need to
operate the system.
Power-saving mode: When no actions are made for over 1 0 minutes, the
system will enter power-saving mode. Press any buttons to
enter operation mode.
Measurement Switch (cm/inch): Press "T" for 8s. The buzzer will beep twice.
The measurement is changed from centimeter to inch. If you want to switch
the measurement back to centimeter, also press the "T" for 8s.
Reset Mode: While the system is reconnected, press the down button until
"RST" is displayed. Continue to press the button. The desk will move down
and then raise a little bit. (Make sure you never release the button during the
process.) After the movement stops, the system is successfully reset to the
starting position.
11