Operation Mode; Standby Mode - Concept KS4000 Bedienungsanleitung

EN
OPERATION
Connect the plug into a suitable socket of the same current and voltage as stated on the nameplate.
The touch screen buttons on the appliance match the functions of the remote control:

STANDBY MODE

Before you start using the appliance, turn on the switch located on the side of the appliance. Fig. 1 illustrates what the
display will be showing, now the appliance is in standby mode and it does not heat. Display shows
Press and hold the button to set the hours, press and hold the
the button to set the days, see Fig. 1.
Fig. 1
58
1. Display
2. Receiver
3. Minute selection
4. Mode selection
5. Settings
6. Heating button
7. Temperature +
8. Temperature -
.
button to set the minutes, press and hold
Day
Mode
Minutes
Hours
KS4000/KS4010

OPERATION MODE

Press to change to operating mode. Fig. 2 illustrates what the display will be showing; the display will be showing
.
Press the button to regulate high and low heating power output, when the low power output is selected, the
display will be showing . When the high power output is selected, the display will be showing
Press or to select the desired temperature in the range of 5 °C - 40 °C. The display will show 2 temperatures,
the number on the left displays the current temperature. The number on the right displays the selected temperature,
see Fig. 4.
Mode
Fig. 2
Set temperature
Current temperature
Fig. 4
TIMER WEEKLY MODE
You can set a desired temperature in the operating mode (
in the range of 5 °C - 40 °C.
Press the button to switch to the timer's weekly mode, the display will show
Press the button to select the weekly mode; e.g. from Monday to Friday, Monday to Saturday, Wednesday, Friday,
etc., see Fig. 6.
Press the button to set the start time, then press the button
setting the start and end time of the operation, keep pressing the
series. At this point, the operation of the convector is set to the desired days, times and heating power output, see
Fig. 7. For example, if you want the convector to heat at the weekend from 8:00 to 10:00, press the
a weekend mode (SAT, SUN), then keep pressing the
pressing until the display shows 10:00. Finally keep pressing
KS4000/KS4010
EN
, see Fig. 3.
High heating power
output
Low heating power
output
Fig. 3
). Press or to select the desired temperature
, see Figure 5.
to set the end time of the operation. After
button until you reach the end of the numerical
button to select
button until you the display shows 8:00. After that keep
, until you reach the end of the numerical series
59