DJI Multilink Bedienungsanleitung Seite 5

The CAN cable can be also be connected to the Patch Antenna module
if a Patch Antenna is used. Make sure the Patch Antenna is connected
correctly.
Assigning Roles
The following steps explain how to set the Multilink as master or slave remote
controller. There are three roles that you can assign for the slave remote
controller: Gimbal Operator, Assistant A, and Assistant B.
Master remote controller
1. Turn on the remote controller. Make sure the Multilink is connected correctly.
2. Set the Multilink as master remote controller using the Remote Controller
Setting page in DJI GO
3. Set an access password.
Slave remote controller
1. Turn on the remote controller. Make sure the Multilink is connected correctly.
2. Set the Multilink as slave remote controller using the Remote Controller Setting
page in DJI GO 4 app. Determine which role you would like to assign to the
slave, and then select the desired role in DJI GO 4 app. At this time, the
Status Indicator of the Multilink will light up steady purple.
3. Enter the access password.
4. The Status Indicator will turn steady green after the role is successfully
assigned. The remote controller icon shown in app will turn to
5. If you'd like to switch a slave to a different role, go to the Remote Controller
Setting page in DJI GO 4 app to do so.
Usage Details
1. The Master can control the aircraft, gimbal, camera and vision systems.
2. Slave 1 can control the gimbal and camera.
3. Slave 2 and 3 can only control the camera (can be disabled in Remote
Controller Setting page).
• Firmware upgrades can be handled in DJI GO 4 app by connecting
the Multilink to the remote controller.
• The CAN port on the Multilink can be connected to other DJI devices
with a CAN port.
• For best results, use the Multilink together with a Patch Antenna.
• The Multilink will make a beeping sound every time it is connected or
disconnected.
4
TM 4 app.
.