Installation And Connection - DJI Multilink Bedienungsanleitung

Each controller is responsible for the following:
Master–Pilot, Slave 1–Gimbal Operator, Slave 2–Assistant A, Slave 3– Assistant B
• Gimbal control
The Master remote controller and Slave controller 1 can both control the
gimbal, but not simultaneously. Slave 2 and Slave 3 cannot control the
gimbal.
• Camera control
Camera control is shared between all of the remote controllers.
• Support for Inspire 2 and Cendence remote controllers
Both the Inspire 2 and Cendence remote controllers can be used as a master
or slave.
Overview
Antenna
Inspire 2 Remote
Controller Mount
Locking Knob
Mounting Arm
Cendence Remote Controller Mount
Usage

Installation and Connection

Multilink can be installed onto both the Inspire 2 Remote Controller and
Cendence Remote Controller using different holes on the mounting arm. Their
installation steps are otherwise similar. The steps provided below use the
Cendence as an example.
1. Mount the Multilink module onto the back of the remote controller and
tighten the locking knob to secure it.
2. Connect the CAN cable to the remote controller's CAN port.
Status Indicator
CAN Port
CAN Cable
3