Disclaimer And Warning; Product Profile - DJI Multilink Bedienungsanleitung

Disclaimer and Warning

Congratulations on purchasing your new DJI
document affects your safety and your legal rights and responsibilities. Read this
entire document carefully to ensure proper configuration before use. Failure to
read and follow instructions and warnings in this document may result in serious
injury to yourself or others, damage to your DJI product, or damage to other
objects in the vicinity. This document and all other collateral documents are
subject to change at the sole discretion of DJI.
By using this product, you hereby signify that you have read this disclaimer
and warning carefully and that you understand and agree to abide by the terms
and conditions herein. You agree that you are solely responsible for your own
conduct while using this product, and for any consequences thereof.
You agree to use this product only for purposes that are proper and in accordance
with all applicable laws, rules, and regulations, and all terms, precautions,
practices, policies and guidelines DJI has made and may make available.
DJI accepts no liability for damage, injury or any legal responsibility incurred
directly or indirectly from the use of this product. The user shall observe safe and
lawful practices including, but not limited to, those set forth in this document.
Notwithstanding above, your statutory rights under applicable national legislation
are not affected by this disclaimer.
DJI is a trademark of SZ DJI TECHNOLOGY CO., LTD. (abbreviated as "DJI")
and its affiliated companies. Names of products, brands, etc., appearing in this
document are trademarks or registered trademarks of their respective owner
companies. This product and document are copyrighted by DJI with all rights
reserved. No part of this product or document shall be reproduced in any form
without prior written consent of or authorization from DJI.

Product Profile

Introduction
Multilink is designed specifically for use with the INSPIRE
and CENDENCE TM
network with up to three slave remote controllers. The multiple slave controllers
form a star network with the master controller as the hub, sending commands
to the aircraft via the slave controllers.Slave controllers receive the image and
video signal from the aircraft directly.
Features
• Master-slave network
Can create a master-slave network with up to three slave remote controllers.
2
remote controller. It can create a master-slave controller
TM product. The information in this
2 remote controller
TM