Herunterladen Diese Seite drucken

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 20
The power supply leads and connection
cables must be secured using the cable
clamp included in the container.
- Connect the earth wire of the motor to
the earth wire of the electrical system
using the special terminal, as illustrat-
ed in the connection diagram.
- The control unit is not equipped with a
230 V a/c electric line sectioning device.
The installer is responsible for installing
a sectioning device in the system. The
sectioning device must be positioned
so that it is protected against acciden-
tal closure, in compliance with section
5.2.9 of EN 12453.
- The motor reducer used to move the
shutter must comply with section 5.2.7.
of EN 12453.
- For the radio receiver to operate correct-
ly when two or more control units are
used, we recommend that you install
the devices at least 3 metres away from
each other.
BeSUN
are in compliance with the specifics of
RED 2014/53/EU, EMC 2014/30/EU, LVD 2014/35/EU
Directives.

TECHNICAL DATA:

- Power supply
- Motor output
- Working temperature
- Radio receiver
- Compatible radio controls
- Anemometer sensitivity
- Sun sensor sensitivity
- Number of codes that may be stored
- Packaging dimensions
- Container
CONNECTION OF CN 1 TERMINAL BOARD:
1: Earth
2 : 230V line input (Phase).
3 : 230V line input (Neutral).
4 : Upward movement motor output.
5 : Shared motor output.
6 : Downward movement motor output.
INITIAL OPERATING CONDITION:
The device can only operate in conjunction with one or more radio controls. There is no
radio control code stored in the default factory setting.
10
: 230V~ 50/60Hz 2,5 W
: 230V~ 500W Max.
: -10 ÷ 60 °C
: see model
: 12-18 Bit or Rolling Code
: 5 ÷ 40 Km/h
: 5 ÷ 40 Klux
: 4 Max
: 240x185x110 mm.
: PC UL94V-0 (IP54)

Werbung

loading

Diese Anleitung auch für:

Besun 433Besun 433 setBesun 868