Exploitation; Temperature Regulation; Fig.3 Control Panel Of The Cabinet - Igloo SYLWIA Bedienungsanleitung

1
2

4. EXPLOITATION

Temperature of cooled space and operating cycle of the aggregate may vary. It depends on numerous factors, such
as amount and temperature of products placed in the device and temperature of the surroundings.
The device should be placed in a dry place, not insulated and well ventilated, ensuring proper air circulation (min. 10
cm distance between the wall and the device), far from sources of heat and devices forcing the air circulation (roof
ad mobile ventilators, blowing heaters). The device operates properly in an environment, where temperature falls
within proper climate class stated on the data plate. The operation of the device may worsen, when it will operate in
temperature higher or lower than the one determined in the stated temperature range.
Remarks and indications
• After transporting the device, wait about 2 hours before its actuation.
• The fi rst fi lling of the freezing space should be performed after its previous cooling to working temperature. This
principle should also be observed after longer pause in exploitation.
• Do not insert hot products into cooling devices.
• Do not block any ventilation holes, which would hamper the cooled air circulation. It is necessary to ensure proper
airfl ow around the device (aggregate ventilation holes cannot be covered).
• Keep the condenser clean. Impurities may lead to overheating of the compressor and as a consequence may
result in damage of the device, which is not covered by warranty.
• Do not use electric devices inside grocery product storing chamber

4.1. Temperature regulation

"Igloo" and "Carel" thermostat (temperature regulators) service is described in chapter 7 (p.17 and 18)
The basic aim of a thermostat is to control the cooling aggregate to obtain the set temperature within the device and
maintain it within the determined temperature ranges. The producer enters all settings of temperature regulators required
for normal functioning of the device. Before primary actuation the user should control and possibly set the required tem-
perature inside the device on the control panel.
Digital display – displays the current temperature inside the device.
It is forbidden to interfere with systemic parameters of the thermostat, as this can lead to serious consequ-
ences, including the damage of the cooling device!
www.igloo.pl

Fig.3 Control panel of the cabinet

1 – Thermostat panel (temperature regulator)
3
2 – Main switch (turns on/ off the aggregate of the device)
3 – Illumination switch
(service details in Chapter No. 7 on p.17 or 18)
en
13
User manual Sylwia