Cleaning And Maintenance - Concept OV5200 Bedienungsanleitung

EN

CLEANING AND MAINTENANCE

Before each cleaning of the appliance, unplug the power cord from the electrical outlet!
To clean the surface of the appliance, use only a damp cloth, no detergents or hard objects, as they can damage the
surface of the appliance!
Clean and inspect the input and output grids of the appliance frequently to ensure good operation of the appliance.
Never clean the appliance under running water, do not rinse it or immerse it in water!
If the fan is dismantled, proceed in the reverse order of installation.
If dust is collected on the surface of the appliance, wipe it with a soft cloth. If the surface of the appliance is dirty, mix
water at a temperature of up to 50° C with a neutral detergent and then wash the surface with a cloth and then dry it.
Do not use gasoline, thinner or other substances that could easily damage the surface of the appliance.
Cleaning the air and water filter
If there is too much dirt attached to the filter, it will affect the air flow. Therefore, the air filter should be cleaned at
least once a month.
1. Disconnect the power cord.
2. First, remove the air filter and then remove the water filter (see figure below).
3. Clean the air filter with a detergent and a soft brush.
4. Leave the water filter in the cleaning solution for a few minutes and then rinse and dry it.
Cleaning the water tank
1. Disconnect the power cable, turn the water tank lock to the horizontal position and remove the water tank.
2. Slightly moisten the cloth with a detergent and wipe the water level gauge on the water tank. Then wash it with
clean water and pour out the dirty water.
Cleaning the surface of the appliance
• The surface of the appliance can be cleaned with a damp cloth, do not rinse it directly under the water.
• Do not use corrosive cleaners or solvents for cleaning.
• Before cleaning, first switch off the appliance and disconnect the power cord, otherwise it may cause electric shock.
Installation and use after cleaning
1. Gradually install the air filter, water filter and the water tank and make sure all parts are in place.
2. Plug the appliance into the socket and make sure it is working properly.
Maintenance
• If you do not use the appliance for a long period of time, disconnect the power cord, cover the appliance and secure
it against dust.
• The air and water filters should be dry before packing and there should be no water in the water tank.
60
OV5200