Protection Features - Concept OV5200 Bedienungsanleitung

EN

Protection features

Protection against lack of water in the water tank
1. If the software detects that the water protection in the water tank is turned off for more than 5 seconds while the
water pump is running for 45 seconds, the water pump stops and an alarm sounds for 10 seconds.
2. If you press the Cooling/Humidification button 3 times within 3 seconds after the switching on the appliance is
switched on, a beep sounds (the same sound as when the heater is forced to warm up within 5–50° C) and the
appliance switches to the fast water detection state of the tank.
3. In the state of fast detection of low water level in the tank, press the on/off button, then press the cooling/
humidification button. The appliance detects a shortage of water within 3 seconds (initially within 50 seconds) and
triggers a water shortage alarm.
4. To cancel the quick detection of low level of water press the on/off button.
Water tank removal protection
After removing the water tank from the appliance, power is turned off and a beep sounds. Once the tank is put back into
the appliance, a beep sounds and the power goes into the stand-by mode.
Memory function during power failure
• If the appliance is switched on after a power failure, a beep sounds 10 times in an interval of 1 second and the
display is off and the appliance is not running. After 30 seconds, the previous mode and all functions are restored.
• If you press the on/off button within 30 seconds, the previous mode will resume immediately.
• If a power failure occurs when the appliance is switched off, the appliance remains switched off after the power is
restored.
Automatic shutdown function
If the appliance is running continuously for more than 15 hours in the default mode and no operation is performed, the
appliance switches off automatically. If you want to cancel this function, press and hold the cooling and mode buttons
for 3 seconds, a beep sounds, and the automatic shutdown function turns off. If both buttons are pressed again, a beep
sounds and the automatic shutdown function is activated again.
Water refilling
Before the cooling and humidification function is turned on, refill the water tank with water. Before refilling the water,
first open the water tank lock (Fig. 2), remove the water tank (Fig. 3) and carefully fill it with water (Fig. 4). After filling
in water, return the water tank back to its original position and secure it with the rotating knob (Fig. 1).
Fig. 1
58
Fig. 2 Fig. 3 Fig. 4
OV5200